Install the Battery in DuraLabel Toro

Overview

Toro?s battery is an optional accessory. The Lithium-Ion (Li-ion) battery lets you design and print labels on the go, even without an AC power supply. Typically, a fully charged battery will allow for about three hours of continuous printing, or 30 hours of sleep mode.

A Toro battery can usually be fully recharged in about three hours. During charging, make sure to put the battery on a clean, dry surface, away from heat or direct sunlight. Because Lithium batteries self-discharge over time, it is recommended that you fully recharge the battery at least once every three months.

Battery Loading

The battery mounts into the back of the Toro. Remove the battery cover door by pushing the slider downward and pulling the door away. Position the battery so the cut-outs are aligned and the contacts are in position with the contact interface. Push the battery in until it locks into place.

Charging the Battery

The Toro battery should be charged only with the charging unit provided. Plug the charging unit into the Toro battery and place the battery on a clean and dry surface. Then, plug the charger into an AC outlet. The light on top of the charger will glow red. When the charger light turns green, the charge is complete. A typical charging time is three hours; do not leave the battery connected to the charger for more than 24 hours at a time.

Battery Maintenance

When the battery is not in use, keep it in a cool, dry place, away from heat or direct sunlight. Do not disassemble your Toro battery. Do not let the metal battery pins come into contact with another metal surface. If you notice any unusual odor, leakage, or swelling in the Toro battery, discontinue use and contact your DuraLabel representative.

More Support Options

If you have any questions about using your DuraLabel Toro printer, get help from DuraLabel? world-class support team by calling 800-788-5572 or visiting DuraLabel.com. We?re here to help with all your labeling needs!