If the size of the supply loaded is too small, it may not be able to hit the sensor consistently. To resolve this, DuraLabel offers tape guides that can be clipped onto the sensors and help position the supply.
Tape Guide & Shrink-Tubing Sizes
There are four sizes of tape guide and shrink-tubing supply:
1/2" TG
1/4" ST
1/8" ST
3/16" ST
NOTE: For labeling supply purposes, Tape Guides and Shrink-Tubing are commonly referred to by the abbreviations TG and ST.
For Toro Max, the instructions in this article apply to the following small-sized supplies:
NOTE: 3/8" Shrink-Tubing and 1/2" Tape with Reveal Edge no longer require an extra guide.
How to Install Additional Tape Guides
Slide the standard guides back. With no guide installed, you will see a half circle on either side of the gap where the guide will sit.
Place the detachable guide over the middle point above the sensor. When inserted, the bottom of the guide should rest on these half circles.
Press down to snap the detachable sensor into place.
Once the guide is clipped in, you can load your supply.
How to Remove Additional Tape Guides
Squeeze the tabs on either side of the guide.
Rock the guide to one side and gently remove.
More Support Options
If you have any questions about using your DuraLabel Toro Max printer, get help from DuraLabel' world-class support team by calling 800-788-5572 or visiting DuraLabel.com. We're here to help with all your labeling needs!
.png){kind=logo}
