How-To Load Supply in a DuraLabel Lobo Label Printer

Load Supply in a DuraLabel Lobo Label Printer

Video Transcription

Lobo supply cartridges contain both the ribbon and supply described on the top of each cartridge.

To load your logo, position the supply cartridge face up above the cartridge compartment. The label supply should be exiting the left side.

Next, lower into place so the cartridge lock goes through the hole.

Before the supply cartridge can be locked into place, the top must be completely flush with the printer.

Because the cartridge is spring loaded, lightly push down to make it flush with the printer, and then turn the cartridge lock clockwise one quarter rotation.

This locks the cartridge and prepares your logo for printing.

To remove the supply cartridge, simply turn the cartridge lock counterclockwise one quarter rotation.

Grip the cartridge on the indented spaces at the front and back and lift up.

Lobo can be left on when switching supply cartridges.

The new cartridge will automatically be detected when loaded. You will then have an option to either save the label that was being worked on or delete it.

For more information about the DuraLabel Lobo, call 800-788-5572 or visit us online at DuraLabel.com